Radyne QAM256 Bedienungsanleitung PDF herunterladen (Seite 44)

User Manual

Chapter 2. Installation

Page 2-10 P/N 2349-72712-01

Table 2-4: E-1000 Dialog Parameters – Encoder

Configuration Tab

PARAMETER DESCRIPTION

IP Address Changes the IP Address of the Encoder device.

Base Port Changes the Port number of the Encoder. Should

normally be 161.

Num. Of Port The encoder uses several communication ports to

split the amount of data between all the ports.

The ports that are being used are all the ports from

[Base Port] to [Base Port + Num. of Port].

The following port is used in the example above:

161.

Notification Port This parameter value is 162 and should not be

changed.

Community Changes the SNMP community. The syntax of the

encoder community name is: “E1000-X.X.X.X”.

Where X.X.X.X is the IP address of the encoder.

The community name is case sensitive.

Notif. Type Selects the type of notifications from the proxy:

Inform or Trap.

This parameter default value is “Trap” and should

not be changed.

Retransmit Policy –

Timeout (sec)

This parameter value is 10 by default and should not

be changed.

Retransmit Policy –

Retries

This parameter value is 3 by default and should not

be changed.

4. Select Encoder Inventory Tab (see Figure 2-8). Table 2-5 explain the parameters on the

Encoder Inventory dialog box.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 197 198

Keine Kommentare

Radyne QAM256 Bedienungsanleitung Seite 44