Radyne DMDVB20 LBST Betriebsanleitung Seite 69
- Seite / 113
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Rear Panel Interfaces DMDVB20 LBST Satellite Modem
5-2 TM138 – Rev. 1.0
5.2 Power Input Modules
5.2.1 AC Power Input Module
AC Input Module (Figure 5-1) is located on the left side of the unit. Power applied to the port with
the supplied power cable is 100 – 240 VAC, 50 – 60 Hz. Integrated into the Power Input Module
is the Power On/Off Rocker Switch. Power consumption for the unit is 1A. A chassis ground
connection (#10-32 threaded stud), is located to the lower right of the module .5.2.2 DC Power
Input/Switch
The Optional DC Power Input and Switch (Figure 5-1) is available for all DMDVB20 LBST
products. The unit may be powered from a 36 – 75 VDC source with a maximum unit power
consumption of 3 A. Refer to Table 5-1 for pinouts.
Table 5-1. DC Power
A –
B Ground
C +
5.3 DMDVB20 LBST Chassis Connections
5.3.1 EXT REF (J10)
The External Reference Port is a 50-Ohm Female BNC Connector and will accept the following
frequencies: 1.0, 1.544, 2.0, 2.048, 5.0, and 10.0 MHz.
5.3.2 TX L-Band IF (J11)
The Transmit Output Port is a 50-Ohm Type-N Connector. The power level is programmable
from 0 to -25 dBm, in 0.1 dBm steps. The IF Frequency can be programmed to 950 – 2050 MHz,
in 1 Hz Steps.
5.3.3 RX (J1)
The Receive Input Port is a 75-Ohm F-Type Connector. The IF Frequency can be programmed
from 950 to 2150 MHz in 1 Hz Steps.
5.3.4 ALARM (J15)
The Alarm Port is a 15-Pin Female “D” Connector. Refer to Table 5-2 for pinouts.
Table 5-2. ALARM Port 15-Pin Female “D” Connector (J15)
Pin No. Signal Name Signal Direction
1 Mod Fault MF-C No Direction
2 Mod Fault MF-NC No Direction
3 Mod Fault MF-NO No Direction
4 Demod Fault DF-C No Direction
- DMDVB20 LBST 1
- Warranty Policy 2
- Preface 4
- Trademarks 5
- Copyright 5
- Disclaimer 5
- Record of Revisions 5
- Table of Contents 6
- TM138 – Rev. 1.0 ix 8
- TM138 – Rev. 1.0 xi 10
- Introduction 12
- 1.1.1 Feature Upgrades 13
- 1.1.3 Hardware Options 13
- 1.2 Function Accessibility 13
- TM138 – Rev. 1.0 1-3 14
- Installation 15
- 2.1 Unpacking 16
- 2.2 Removal and Assembly 16
- 2.3 Mounting Considerations 17
- 2-4 TM138 – Rev. 1.0 18
- 2.5 Modulator Checkout 19
- 2.5.1 Initial Power-Up 19
- 2.6 Storage 19
- 2-6 TM138 – Rev. 1.0 20
- Theory of Operation 21
- 3-2 TM138 – Rev. 1.0 22
- 3.1.1 Front Panel 24
- 3.1.2 Baseband Processing 24
- TM138 – Rev. 1.0 3-5 25
- 3-6 TM138 – Rev. 1.0 26
- 3.3 Internal Clock 27
- TM138 – Rev. 1.0 3-9 29
- 3.5 Clocking Options 30
- 3.5.1 TX Clock Options 30
- 3.5.2.1 RX SAT Clock 32
- 3.7.3 Interleaving 33
- 3-14 TM138 – Rev. 1.0 34
- TM138 – Rev. 1.0 3-15 35
- 3-16 TM138 – Rev. 1.0 36
- User Interfaces 37
- 4.1.3 Numeric Keypad 38
- 4.2 Parameter Setup 40
- 4.3.1 Main Menus 40
- TM138 – Rev. 1.0 4-5 41
- 4-6 TM138 – Rev. 1.0 42
- TM138 – Rev. 1.0 4-7 43
- 4-8 TM138 – Rev. 1.0 44
- TM138 – Rev. 1.0 4-9 45
- 4-10 TM138 – Rev. 1.0 46
- TM138 – Rev. 1.0 4-11 47
- 4-12 TM138 – Rev. 1.0 48
- TM138 – Rev. 1.0 4-13 49
- 4-14 TM138 – Rev. 1.0 50
- TM138 – Rev. 1.0 4-15 51
- 4-16 TM138 – Rev. 1.0 52
- TM138 – Rev. 1.0 4-17 53
- 4-18 TM138 – Rev. 1.0 54
- TM138 – Rev. 1.0 4-19 55
- 4-20 TM138 – Rev. 1.0 56
- TM138 – Rev. 1.0 4-21 57
- 4-22 TM138 – Rev. 1.0 58
- TM138 – Rev. 1.0 4-23 59
- 4-24 TM138 – Rev. 1.0 60
- TM138 – Rev. 1.0 4-25 61
- 4-26 TM138 – Rev. 1.0 62
- TM138 – Rev. 1.0 4-27 63
- 4-28 TM138 – Rev. 1.0 64
- 4.4 Terminal Mode Control 65
- 4.6 Connecting the Terminal 66
- 4.7 Terminal Screens 66
- TM138 – Rev. 1.0 4-31 67
- Rear Panel Interfaces 68
- 5-2 TM138 – Rev. 1.0 69
- 5.3.5 EXT CLK (J16) 70
- 5.3.7 (J18) 70
- 5.3.8 EIA-530 (J19) 71
- 5.3.9 REMOTE (J20) 72
- 5-6 TM138 – Rev. 1.0 73
- 6.0 Periodic Maintenance 74
- 6.0.1 Clock Adjustment 74
- 6.1 Troubleshooting 74
- 6.1.1 Alarm Faults 75
- 6.1.1.1 Major Tx Alarms 75
- 6.1.1.2 Major Rx Alarms 76
- 6.1.1.3 Minor Tx Alarms 76
- 6.1.1.4 Minor Rx Alarms 77
- 6.1.1.5 Common Major Alarms 77
- TM138 – Rev. 1.0 6-5 78
- 6-6 TM138 – Rev. 1.0 79
- Technical Specifications 80
- 7.2 Demodulator 81
- 7.3 Monitor and Control 81
- TM138 – Rev. 1.0 7-3 82
- 7-4 TM138 – Rev. 1.0 83
- 7.8.2 DVB 84
- 7-6 TM138 – Rev. 1.0 85
- TM138 – Rev. 1.0 7-7 86
- 7-8 TM138 – Rev. 1.0 87
- TM138 – Rev. 1.0 7-9 88
- Product Options 89
- A-2 TM138 – Rev. 1.0 90
- B.0 Introduction 91
- B.1 Required Equipment 91
- B.2 Upgrade Procedure 91
- B-2 TM138 – Rev. 1.0 92
- B.3 Demonstration Procedure 93
- B-4 TM138 – Rev. 1.0 94
- TM138 – Rev. 1.0 95
- B-6 TM138 – Rev. 1.0 96
- Carrier Control 98
- C.5 Carrier RTS 99
- TM138 – Rev. 1.0 C-3 100
- Strap Codes 101
- D.1 Sample Applications 104
- TM138 – Rev. 1.0 D-5 105
- D-6 TM138 – Rev. 1.0 106
- TM138 – Rev. 1.0 D-7 107
- Glossary 108
- G-2 TM138 – Rev. 1.0 109
- TM138 – Rev. 1.0 G-3 110
- G-4 TM138 – Rev. 1.0 111
- TM138 – Rev. 1.0 G-5 112
- G-6 TM138 – Rev. 1.0 113
Verwandte Produkte und Handbücher für Modulator Radyne DMDVB20 LBST
Modulator Radyne DM240XR Spezifikationen
(196 Seiten)
(196 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.101 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern